LILYGO T-LoRa Pager is an ESP32-S3-based device with LoRa, GNSS, NFC, and AI motion detection, for off-grid text messaging and tracking.

Realtek has unveiled the low-cost RTL8127 10GbE PCIe controller, RTL8159 10GbE USB 3.2 controller, and RTL8261C PHY at Computex 2025 ...

The Rockchip RK3588 is one of the most popular Arm SoCs for single board computers, and while good progress has been made with regards to mainline u-boot and Linux support, the SoC is quite complex ...

The Raspberry Pi RP2350 microcontroller adds an HSTX (High-Speed Serial Transmit) interface adding the PIOs (Programmable IOs) introduced on the Raspberry Pi RP2040 three years ago. The RP2350 MCU now ...

The Amlogic S905X5 may be first the Armv9 processor designed for set-top boxes (STB) and TV boxes, supports the latest AV1 and H.266 video codecs, and also comes with a 4 TOPS AI accelerator. We don’t ...

Review of a USB 3.0 to 2.5Gbps Ethernet adapter based on Realtek RTL8156B using iperf, SAMBA, and scp to evaluate the network performance.

When I completed my review of Raspberry Pi Zero 2 W, I mentioned I would test the power consumption of the board later. It took a while, but I’ve finally come around it using Otii Arc from Qoitech and ...

Allwinner D1s (aka F133) is a cost-down version of Allwinner D1 RISC-V processor introduced earlier this year together with a Linux capable development board, with the main difference being the ...

The Mikron MIK32 is a 32-bit RISC-V microcontroller made in Russia with features similar to an STMicro STM32L0 Cortex-M0+ MCU that shows how RISC-V open-source architecture can help lower the barrier ...

So today we will be talking about Raspberry Pi RP2040 Programmable IOs that make it different from other microcontroller boards.

I reviewed Rikomagic MK22 TV box about two weeks ago, and with the firmware I had, online firmware update was not enabled, and the company only released .IMG firmware for Amlogic USB Burning Tool, a ...

If you’ve ever compiled the Linux kernel, you’ll know make menuconfig is the command line used to unset/set options, disable/enable modules in order to match your hardware and requirements. I used to ...